Cleaning Gas Water Heater Thermocouple

Disconnect any wires from the valve and unthread the nut to release the thermocouple if required by your model.

Cleaning gas water heater thermocouple.

Turn the power on to the hot water heater. Before cleaning the thermocouple make sure that you shut off the power supply so that you do not get hurt while cleaning the thermocouple. Place these safely on the ground. Cleaning the thermocouple is a pretty simple process but should only be done when the fireplace is turned off and is completely cool.

Your water should heat up within a little while. Want to say thanks for the video. You really don t want hot water spilling everywhere causing property damage. Turn on the water heater.

It s free for you to use and amazon pays a small commission https amzn to 33i9exy purchase wa. Using a wrench or similar tool unscrew each of the leads going into the tankless water heater. Be aware you may need to detach a pilot supply tube as well. Water heater thermocouple cleaning in 5 steps shut the gas inlet valve safety first.

The thermocouple on a gas fireplace may eventually become clogged with dirt and soot which can reduce the effectiveness of the thermocouple and may eventually prevent the fireplace from lighting as expected. This may prevent power from reaching the pilot lights. After scrubbing further clean the thermocouple of the water heater with a microfiber cloth to remove excess particles. Keep the new thermocouple clean so that it continues working properly.

This is always the first step when working on a water heater. Unthread the nut to detach the burner supply tube from the gas or control valve. Use my amazon link to shop. If applicable detach the vapor sensor from the tank base.

Cut the fuel supply to the water heater. Completing these simple steps will prevent problems and will lengthen the life of your thermocouple. Once you re sure the thermocouple is clean fix it back to the unit. If you ever see residue on the ends of it remove it with an emery cloth.

Rub the ends of this piece with an emery cloth sandpaper. Of course always ensure that there is no water in the actual tank before you do this if you even have a tank. If the thermocouple is working you should be able to measure 30 to 40 millivolts of voltage at the connection end of the tube when the pilot flame is on. Remove dust with a lint free cloth.