Circuit Breaker Frame Size Rating

And cedar rapids iowa respectively.

Circuit breaker frame size rating.

To determine the appropriate size of circuit breaker for single phase supply it depends on multiple factors like type of load cable material and environment temperature etc. Although 100 rated devices typically are not available in sizes this small the permitted rating would still be 50a 16a 30a 46a. Interrupting ratings like 10k 22 5k and 65k rms ensure the breaker has an interrupting rating sufficient for the maximum possible fault current available on the line side terminals of the equipment. The rated continuous current of a circuit breaker equipped with direct acting trip devices or fuses of a lower rating than the frame size of the circuit breaker is determined by the rating of those devices.

Next up in current quantity this same breaker must be able to open overload level currents. Paragraph 9 1 4 4 of ul standard 489. Overloads for our purposes can be understood by reference. In the range of molded case circuit breakers conforming with the ul 489 and csa c22 2 standard abb proposes an entire range which covers current ratings between 15 a and 2500 a and interrupting ratings at 480 v ac which can reach 150 ka.

And intended for continuous operation at 100 percent of rating shall be marked. A circuit breaker having a frame size of 250 a or greater or a multi pole type of any ampere rating rated over 250 v. Jim pauley is manager industry standards and sandi young is circuit breaker product specialist with square d co lexington ky. The general rule of thumb is that circuit breaker size should be 125 of the ampacity of cable and wire or the circuit which has to be protected by the cb.

Rounded up to 50a.